When opening and closing jump rings to get the perfect close it helps to use two flat-nose or chain-nose pliers. Place the the ends of each pliers on either side of the opening. You will work in a wiggle motion moving the right side up and left side down (DO NOT PULL APART). While moving them back and forth open the ring only as wide as you need. To close position your pliers in the same position and move them back and forth and over lap the sides of the ring so there is tension when the two sides meet and the seam should be closed tightly.
Learn To Bead
For the head pin try and use brass head pins (iron is fine but it is not as soft as brass to work with). Also if you can try and source findings which are nickel & lead free. A lot of people are allergic to nickel and lead is dangerous is swallowed (more for young children)
CREATING THE WRAP LOOP
1. Take one of your head pin and thread the bead on it. Place the tip of your round nose pliers on top of the bead (picture 2). Now bend your head pin at a 90 degree angle (picture 3).
2. Now take your round-nose pliers and place it on the top of the angle (not a the tip this time, a little bit inwards to give your loop a nice size) and starting wrapping the wire around the nose of the pliers (picture 4) This would have created half the loop.
3. To create the other half of the loop change the position of the pliers (picture 5). Once you are happy with the shape of the loop (picture 6) then you thread the bottom loop of the setting (picture 7).
4. Now take the tip of your round-nose pliers and hold the loop together (picture 8). Take your flat-nose pliers and take the end of the wire and start wrapping it around the wire on the bottom of the loop. Starting at the top working to the bottom. Once you have reached the bottom trim the wire and finish neat.
FINISHING THE EARRING
5. Take the cabochon and glue it to the setting. I used E6000 but any jewellery or craft glue would work.
7. Take the ear hook and using the round nose-pier gently undo the loop on the bottom. Thread the top of your setting. Once attached gently close the loop.
You will need a long head pin (our head pin measured 50mm), some beads and/or bead spacers to stop the head pin from going through the hole in the pendant (and it also gives a nice decorative look). We used a 8mm metal daisy spacer bead and a 4mm bicone.
Take the head pin holding the ends with the tips of your round-nose pliers. Thread the bicone bead, spacer bead and then the pendant. Keep holding the tip of the round-nose pliers on the end of the head pin and take the other end of the head pin and bend it at a 90 degree angle at the back of the pendant. Now move the round nose pliers to the top of the pendant and bring the end of the head pin around it to the front of the pendant creating a large loop (the bail). *Thread a closed loop on the large loop** (* to ** is optional depending on your finished design). Sit the end of the head pin under the beads. Now secure by wrapping the ends of the wire under the beads. Trim if needed.